Replacing A Hot-Swap Expansion Card - Gateway 995 User Manual

Chapter 4: Installing Components

Replacing a hot-swap expansion card

Expansion cards installed in PCI card slots 5 through 8 can be replaced while
the server is on. If you are installing a card into the slot for the first time, see
"Installing an expansion card" on page 79
Caution
To replace a hot-swap expansion card:
1
Remove the top rear panel. For instructions, see
panel" on page
2
Identify the failed expansion card. A green LED indicator above the card
means the card is functioning normally, and a yellow LED indicator means
the card has failed.
82
When hot-swapping a card, the failed card must be
replaced by an identical card. If the card is a different type,
turn off the server and disconnect power before changing
cards.
41.
www.gateway.com
for instructions.
"Removing the top rear
Card operating
correctly
Card has failed