■
Turn off your server, then remove the CD drive and reinstall it. For
instructions, see
Your CD drive tray does not open
■
Press a straightened paper clip wire into the CD drive's manual eject hole.
The drive tray opens.
■
If this problem happens frequently while the server is turned on, the drive
may be defective.
Diskette drive
The diskette drive is not recognized
■
Restart your server.
■
Turn off your server, then remove the diskette drive and reinstall it. For
instructions, see
The diskette drive LED is lit continuously
■
Remove the diskette from the drive. If the light stays on, try restarting your
server.
■
Turn off your server, then remove the diskette drive and push it in again
to make sure that the drive is seated correctly. For instructions, see
"Replacing the diskette drive" on page
Expansion cards
Your server does not recognize an expansion card
■
Restart your server.
■
Make sure that you have installed the necessary software or driver. For
instructions, see the card's documentation.
■
Reseat the expansion card. For instructions, see
cards" on page
■
If another slot of the correct size is available, install the card in a different
slot.
"Replacing the CD drive" on page
"Replacing the CD drive" on page
79.
www.gateway.com
75.
75.
77.
"Installing expansion
Troubleshooting
139