Replacing The Romb Battery Pack For The Mezzanine Raid Card - Gateway E-9425R User Manual

www.gateway.com
Replacing the ROMB battery pack for the mezzanine RAID
card
Danger of explosion if the battery is
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of or recycle used batteries by
taking them to a hazardous waste
facility. Follow all local regulations for
correct battery disposal.
Follow the instructions in
12
Reinstall the hot-swap drives back into the server. Make sure that you
13
install the drives into the same bays you removed them from in
instructions see
Replace the bezel by snapping it into place on the front of the server.
14
To replace the ROMB battery pack for the mezzanine RAID card:
Warning
Follow the instructions in
1
page
cord(s) and all other cables connected to the server.
Follow the instructions in
2
Press the release handle (1), then slide the ROMB battery pack for the
3
mezzanine RAID card (2) toward the back of the chassis to release it from
the locking tabs and lift it out of the chassis (3).
Align the holes in the bottom of the new ROMB battery pack for the
4
mezzanine RAID card (1) with the locking tabs in the chassis, then press
it into place in the chassis.

Replacing the ROMB battery pack for the mezzanine RAID card

"Closing the server case" on page
"Removing and installing a hard drive" on page
"Preventing static electricity discharge" on
30. Make sure that you turn off the server, then unplug the power
"Opening the server case" on page
32.
Step 4. For
36.
31.
55