Gateway 995 User Manual page 37

Setting up LAN alerts
To set up LAN alerts:
1
Boot your server from the Server Companion CD, then select
from the menu. The System Setup Utility starts.
Utility
2
In the SSU Main window, click
3
In the PEM window, click
4
Click to select the
5
In the
SNMP Community String
community field in the
The string must be from 5 to 16 characters. The default string is
6
In the
IP Setup
■
DHCP
DHCP (dynamic host control protocol) server on the network. The
Host, Gateway, and Subnet Mask boxes in the dialog box are ignored.
■ Static
and Subnet Mask boxes in the dialog box.
7
If you chose
boxes:
■
Host IP Address
■
Gateway IP Address
■
Subnet Mask
this to decide if the alert destination is on the same subnet.
8
In the
Alert IP Address
the alerts sent to. If you want the alert to be broadcast to an entire subnet,
enter the IP address for the subnet.
9
Click
Options
Configure LAN
Enable LAN Alerts
Header
box, click either:
—The IP address for the server is automatically assigned by the
—Assign the IP address for the server using the Host, Gateway,
IP Setup in the previous step, complete the IP addressing
Static
—The IP address of this server.
—The IP address of the router for this server.
—The IP address for the server's subnet. The server uses
box, complete the IP address of the system you want
, then click
Configure Event Actions
www.gateway.com
Platform Event Manager (PEM)
.
check box.
box, you can type an optional string for the
section of the SNMP trap sent for an alert.
.
Using the System Setup Utility
System Setup
.
PUBLIC
.
31