Expansion Cards; Replacing An Expansion Card - Gateway 7400 System Manual

Expansion cards

The server has seven PCI expansion slots on the system board, that may be
used for a variety of expansion cards. Two of these slots support 64-bit PCI
cards and five support 32-bit PCI cards. (See "System board" on page 8.)

Replacing an expansion card

To replace an expansion card:
1
Set any jumpers and switches on the replacement card. (See the card
instructions.)
2
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
3
Observe all safety and static electricity precautions. (See "Preventing static
electricity discharge" on page 22.)
4
Remove the bezel. (See "Removing the bezel" on page 25.)
5
Remove the left side cover panel. (See "Removing the side cover panel"
on page 26.)
6
Disconnect any cables attached to the card.
Expansion cards
63