Table of Contents
Advertisement
When you see "Press <F2> to enter Setup" you can press these keys to change
the standard POST routine:
To...
Abort the memory test during POST
Resume after a POST error is displayed
Enter the BIOS Setup utility during POST
Open the boot menu
Boot from a network using Preboot Execution
Environment (PXE)
Remove the splash screen in order to view diagnostic
messages
Enter the Adaptec SCSISelect Utility during POST
Turning off your server
Every time you turn off your server, first shut down the operating system. You
may lose data if you do not follow the correct procedure.
To turn off the server:
1
See the operating system's documentation or online help for instructions
on shutting down the operating system. Whenever possible, you should
use the operating system's shut down procedure instead of pressing the
power button.
Warning
2
If your server did not turn off automatically, press the power button.
- OR -
Press the reset button to reset the server.
The power button on the server does not turn off server
AC power. To remove AC power from the server, you must
unplug the AC power cords from the wall outlet or power
source. The power cords are considered the disconnect
device to the main (AC) power.
www.gateway.com
Starting your server
...Press
S
PACEBAR
F1
F2
F10
F12
E
SC
C
+A
TRL
15
Advertisement
Table of Contents
Troubleshooting
