Gateway 995 User Manual page 75

3
Remove each of the hot-swap hard drives. Make note of the slot each drive
is removed from. For instructions, see
on page 64.
4
Remove the top front panel. For instructions, see
panel" on page 43.
5
Disconnect the SCSI ribbon cable and the three power cables from the back
of the cage.
6
Press the tab on each side of the drive cage with a small, flat tool such as
a scribe or a flat screwdriver.
"Replacing a hot-swap hard drive"
www.gateway.com
Installing drives
"Removing the top front
69