Adding An Expansion Card - Gateway ALR 7300 Maintaining And Troubleshooting

52 Maintaining and Troubleshooting the Gateway ALR 7300 Server
8. Plug the other end of the SCSI cable into the appropriate SCSI connector on
the system board.
9. Arrange the ribbon cable so that it doesn't interfere with chassis or CPU fans,
or block airflow through the system.
10. Reinstall the left side cover of the system and replace the two screws.
11. Plug in the system power cord(s) and power up the system.

Adding an expansion card

The system board has seven (7) expansion slot connectors. The system
board accepts two types of expansion cards: ISA and PCI. Some of the PCI
expansion slots are designed to allow the slot to be shared with a special
purpose expansion card such as a RAIDport card.
Some ISA expansion cards have jumpers or switches that set interrupts and
I/O addresses. They come with instructions that explain how to set them to
avoid hardware conflicts. Follow the instructions carefully.
Refer to Figure 7 on page 14 for the installation locations.
Set any jumpers and switches on the card, if required in the card
1.
instructions.
Turn off the system and disconnect the power cord.
2.
Open the case ("Opening the system" on page 3), observing the static
3.
electricity precautions in "Static electricity precautions" on page 2.
Locate an open slot of the correct type.
4.
To Install an Expansion Card