Replacing The Hot-Swap Hard Drive Cage - Gateway 995 User Manual

Chapter 4: Installing Components
If you are adding a new drive, remove the four screws that secure the hard
drive spacer to the drive tray, then remove the spacer from the tray.
Screw
6
Line up the screw holes in the new drive with the holes in the side of the
drive tray, then secure the drive to the tray with the four screws you
removed in
7
Make sure that the tray's release lever is open, then slide the new drive
into the empty hot-swap bay.
8
Close the drive's release lever.

Replacing the hot-swap hard drive cage

To replace the hot-swap hard drive cage:
1
Follow the instructions in
page
cords and all other cables connected to the server.
2
Remove the front cover, if installed. For instructions, see
front cover:" on page
68
Screw
Step 5.
36. Make sure that you turn off the server, then unplug the power
39.
www.gateway.com
Screw
"Preventing static electricity discharge" on
Screw
"To remove the