Canon imagePROGRAF iPF6400 User Manual page 688

Specifying the Printer's Frame Type
5
Select the IPv4 tab. In IP Address, enter the IP ad-
dress assigned to the printer, and then enter the subnet
mask in Subnet Mask and the default gateway in
Gateway Address.
Important
6
Click Set.
7
Click OK after the Confirmation message is displayed.
8
Exit imagePROGRAF Device Setup Utility.
Specifying the frame type using the printer Control Panel
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Settings/Adj. tab (
•
Note
688
2
Press the OK button.
The Set./Adj. Menu is displayed.
•
You must specify the IP address here to be able to configure NetWare protocol settings using RemoteUI.
).
If the Tab Selection screen is not displayed, press the Menu button.
iPF6400
User's Guide