Canon imagePROGRAF iPF6400 User Manual page 545

Large format printer
Hide thumbs Also See for imagePROGRAF iPF6400:
Table of Contents

Advertisement

iPF6400
Automatic and Eject are valid only when you have selected Auto Cut > Yes in the printer driver.
Note
With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is cut.
Eject is the preset selection in Cutting Mode for some types of paper. For this paper, we recommend keeping the preset
cutting mode.
If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specific amount before cutting
to prevent problems with cutting and paper ejection. This may create a wider bottom margin, in some cases.
Cut rolls manually in the following cases:
Eject (when the paper surface is being scratched / to wait for ink to dry)
When cutting wide printed documents after ejection, have two people support the documents. If the paper drops, printed
documents may be damaged.
Important
Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affect the printing quality or
cause rough cut edges.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
If the Tab Selection screen is not displayed, press the Menu button.
Note
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
6
Press ▲ or ▼ to select Eject, and then press the OK button.
7
Print the job.
When printing is finished, the printer will stop without cutting.
User's Guide
).
Specifying the Cutting Method for Rolls
545

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents