Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 125

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
2
Set up the SNMP environment.
2-1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2-2
In [Category], click [Network].
The [Basic] tab screen of the [Network] screen appears.
2-3
In [Action], click [Setup SNMP Agent Basic Interface].
The [Setup SNMP Agent Basic Interface] screen appears.
2-4
Select "Enable" for "SNMP Function", set the required items in the [Setup SNMP Agent Basic
Interface] screen, and click the [Set] button.
Select the LAN port that was set up in
A confirmation screen appears.
2-5
Click the [OK] button.
The SNMP Agent basic settings are applied.
2-6
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
3
Set up the SNMP Manager.
Set up the SNMP Manager (monitoring server) that is the destination of the SNMP Trap transmission.
This step is not required when ETERNUS SF Storage Cruiser is used to monitor the ETERNUS DX Disk
storage system.
3-1
In [Action], click [Setup SNMP Manager].
The [Setup SNMP Agent Manager] screen appears.
3-2
In the manager list of the [Setup SNMP Agent Manager] screen, click the [Add] button.
The [Manager] screen appears.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Step 1 for "LAN Port used for SNMP".
125
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0