Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 68

Chapter 4 Connecting Cables
4.2 Host Interface Connection
Procedure
1
Remove the connector covers that are attached to the host interface ports (FC, iSCSI 10Gbit/
s, or FCoE) of Controller 0 (CM#0) and Controller 1 (CM#1).
Connector cover
Keep the removed connector covers in a safe place where they will not be lost.
2
Connect the FC cable to the ETERNUS DX Disk storage system.
2-1
Remove the covers from the FC cable connectors.
2-2
Insert the FC cable connectors in the host interface ports (FC, iSCSI 10Gbit/s, or FCoE) of Controller 0
(CM#0) and Controller 1 (CM#1).
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do
CAUTION
• When connecting the FC cables, position them so that they will not
obstruct replacement of the power supply unit or controllers by the
maintenance engineer.
Copyright 2013 FUJITSU LIMITED
68
P3AM-4832-07ENZ0