Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 26

Chapter 1 Preparation
1.2 Setup Preparation
■ Preparation and settings for the PC terminal
The initial settings are performed by using a Web browser on the PC terminal.
Prepare and set up the PC terminal before the initial settings.
❏ Preparing the PC terminal
Prepare the PC terminal that contains the following environment:
- Web browser
Usable Web browsers are as follows. Using Web browsers other than the following is possible, but
proper operation is not guaranteed.
• Microsoft Internet Explorer 7.0, 8.0, 9.0, 10.0 (desktop version)
• Mozilla Firefox 3.6.x, ESR 10.0.x, ESR 17.0.x
• Microsoft Internet Explorer 9.0 and Mozilla Firefox ESR 10.0.x can be used for an ETERNUS DX Disk
storage system with controller firmware version V10L30 or later.
• Microsoft Internet Explorer 10.0 (desktop version) can be used for an ETERNUS DX Disk storage system
with controller firmware version V10L40 or later.
• Mozilla Firefox ESR 17.0.x can be used for an ETERNUS DX Disk storage system with controller
firmware version V10L45 or later.
❏ Setting up the PC terminal
Set up the PC terminal with the following procedure:
Procedure
1
Set the IP address and subnet mask of the PC terminal.
Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
2
Check the settings of the Web browser.
Refer to "ETERNUS Web GUI User's Guide" for details on the settings that are required.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
26
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0