Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 100

Chapter 5 Setup
5.1 Basic Setup
CAUTION
The procedure to register a RAID group is as follows:
Procedure
1
Click the [RAID Group] tab on the navigation of the ETERNUS Web GUI screen.
The [RAID Groups] screen appears.
2
In [Action], click [Create].
The [Create RAID Group] screen appears.
3
Enter the name of the RAID group that is to be registered and select "Automatic" or "Manual"
for "Create Mode".
When "Automatic" is selected, the settings for "Automatic Setting" are displayed.
When "Manual" is selected, the settings for "Manual Setting" are displayed.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do
• Remember that a RAID0 configuration is not redundant. This means that if a
RAID0 drive fails, the data will not be recoverable. RAID1, RAID1+0, RAID5,
RAID5+0, and RAID6 are recommended as the RAID level.
Do Not
• Do not uninstall the drives that are installed by default or move them to any
other slot.
Contact your sales representative or maintenance engineer if drives that are
installed by default need to be uninstalled or moved to another slot.
100
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0