Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 141

Chapter 5 Setup
5.3 Power Control Setup
The procedure to enable the Auto Power function and/or the Power Resume function is described below.
Procedure
1
Start ETERNUS Web GUI.
2
On the navigation of ETERNUS Web GUI screen, click [System].
The [System] screen appears.
3
In [Category], click [System Settings].
The [System Settings] screen appears.
4
In [Action], click [Setup Power Management].
The [Setup Power Management] screen appears.
5
In the [Setup Power Management] screen, select "Enable" for "Auto Power" and/or "Power
Resume".
6
Click the [Set] button.
A confirmation screen appears.
7
Click the [OK] button.
The Auto Power function and/or the Power Resume function setting is applied.
8
Check the setting completion message and click the [Done] button.
The screen display returns to the [System Settings] screen.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
141
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0