Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 119

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
5
In the [Setting based on Severity] tab screen, select the required items.
6
Click the [Error Severity Level] tab.
The [Error Severity Level] tab screen appears.
7
In the [Error Severity Level] tab screen, select the required items.
8
Click the [Warning Level] tab.
The [Warning Level] tab screen appears.
9
In the [Warning Level] tab screen, select the required items.
10
Click the [Informational Level] tab.
The [Informational Level] tab screen appears.
11
In the [Informational Level] tab screen, select the required items.
12
Click the [Set] button to apply the specified settings.
A confirmation screen appears.
13
Click the [OK] button.
The event notification settings are applied.
14
Check the setting completion message and click the [Done] button.
The screen display returns to the [Event/Dump] screen.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
119
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0