Powering Off After Completion Of The Setup Procedure - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 5 Setup

5.6 Powering Off after Completion of the Setup Procedure

5.6 Powering Off after Completion of the Setup Procedure
To turn off the ETERNUS DX Disk storage system, perform one of the procedures below.
• Via the Power switch
Press the Power switch to turn off the ETERNUS DX Disk storage system.
• Via the power synchronized unit
Use the power synchronized unit to turn off the ETERNUS DX Disk storage system.
• When turning off the ETERNUS DX Disk storage system, the power shuts off after the data in the cache
memory is written to the drives. Therefore, it may take one minute (maximum six minutes) for the power
supply to be completely turned off.
• Do not turn off the power of the ETERNUS DX Disk storage system, the network devices that connect the
ETERNUS DX Disk storage system, or the server while the server is operating, as this may result in the loss
of data or prevent data from being saved.
• When using a power synchronized unit for power control, make sure to turn off the power with the server.
Even if the ETERNUS DX Disk storage system is turned off by using the Power switch, the power synchroni-
zation function automatically turns on the power.
This section explains how to use the Power switch to turn off the ETERNUS DX Disk storage system. For other
procedures, refer to the related manuals.
Procedure
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
The READY LED on the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the READY
LED turning off and the POWER LED turning off, the ETERNUS DX Disk storage system power may turn
on.
2
The ETERNUS DX Disk storage system power is turned off.
The POWER LED of the controller enclosure and the POWER LEDs of the drive enclosures are turned off.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Power switch
Copyright 2013 FUJITSU LIMITED
Drive enclosure
Drive enclosure
Controller enclosure
145
End of procedure
P3AM-4832-07ENZ0