Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 71

Chapter 4 Connecting Cables
4.2 Host Interface Connection
The following procedure explains how to connect the LAN cable.
• To help with LAN cable management and prevent incorrect connections, attach labels to the LAN cables
and make a note of connection origins and destinations.
• When connecting LAN cables, check the connector orientation and then firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the connector.
This section describes dual-controller type as an example. Note that there is only Controller 0 (CM#0) for a
single-controller type.
Procedure
1
Connect the LAN cable to the ETERNUS DX Disk storage system.
Insert the LAN cable connectors in the host interface ports (iSCSI) of Controller 0 (CM#0) and Controller
1 (CM#1).
2
Connect the LAN cable to the connection destination.
Connect the connector at the other end of the LAN cable to the connection destination.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do
CAUTION
• When connecting the LAN cables, position them so that they will not
obstruct replacement of the power supply unit or controllers by the
maintenance engineer.
Copyright 2013 FUJITSU LIMITED
71
End of procedure
P3AM-4832-07ENZ0