Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 84
Disk storage system
Hide thumbs
Also See for ETERNUS DX80 S2:
- Cli user's manual (756 pages) ,
- User manual (186 pages) ,
- Overview (97 pages)
Table of Contents
Advertisement
Chapter 4 Connecting Cables
4.5 Power Cord Connection
Procedure
1
Remove the power cord clamp from the power distribution unit.
Loosen the two thumb screws on both sides of the power cord clamp to remove it.
2
Connect the power distribution unit outlets and power supply unit inlets with the power
cords (AC output cables, 4m) provided with the power distribution unit.
The procedures to connect the power supply unit is the same as the
Distribution Units are Installed" (page
•
Each enclosure has two power supply units (PSU#0 and PSU#1). The power cords must be
connected to the inlets of both power supply units.
•
Connect the PSU#0 power cord to power distribution unit#0 (the lower power distribution unit).
Connect the PSU#1 power cord to power distribution unit#1 (the higher power distribution unit).
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Power cord clamp
Copyright 2013 FUJITSU LIMITED
78).
84
Step 1
in
"4.5.1 When no Power
P3AM-4832-07ENZ0
Advertisement
Table of Contents
