Chapter 1 Preparation
1.2 Setup Preparation
1.2
Setup Preparation
Perform the following preparation to set up the ETERNUS DX Disk storage system.
•
Completing and attaching the Network Settings label
•
Preparation and settings for the PC terminal
■
Completing and attaching the Network Settings label
Complete the network setting information in the provided Network Settings label and attach it on the control-
ler enclosure.
❏ Completing the Network Settings label
Complete the following items in the Network Settings label.
-
IP address of MNT port
The IP address for a MNT port of the ETERNUS DX Disk storage system
-
IP address of FST
The IP address for a PC that is used for maintenance operations performed by a maintenance engineer
-
Subnet Mask
Subnet mask of network connected
-
IP address of RMT port
The IP address for a RMT port of the ETERNUS DX Disk storage system
❏ Attaching Network Settings label
Attach the completed Network Settings label on the label plate in the label holder on the rear upper side of
the controller enclosure.
Figure 1.7 Attaching Network Settings label
IP address of MNT port
IP address of FST
Subnet Mask
IP address of RMT port
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Network Settings label
Network Setting
:
:
.
.
:
.
.
:
25
Copyright 2013 FUJITSU LIMITED
.
.
Label holder
Tag
Pull out the plate
while holding the tag.
Plate
P3AM-4832-07ENZ0