Connecting To The Customer's Network; Installing And Wiring Telephones; Completing The Installation; Testing The Complete Installation - Avaya G650 Installing

Media gateway

Hide thumbs Also See for G650:

Table of Contents

Connecting to the customer's network

You can perform this stage anytime. But to allow testing along the way, connect to the customer

network after you cable the media gateways and connect the gateways to the media server

complex.

In this stage, you wire, place, and test the telephones. In most cases, the configuration must be

operational and responsive before you can perform this stage. An exception exists for IP

telephones that are connected to the network, which you can place before you complete the

installation. When you install wiring for traditional telephones and analog or digital consoles,

ensure that you install the telephones when you can also test the telephones.

Note:

The information for this stage is provided in the document, Installing and

Note:

Connecting Main Distribution Frames and Telephones, (03-300686).

In this stage, you finish the installation. To finish the installation, you clear alarms, enable alarm

reporting, back up the servers, connect the modems and register the configuration. This stage

comes at the end of the actual installation.

In this stage, you verify the complete configuration operation. Always perform this stage last.

High-level overview of the installation process

Issue 1 February 2006

Table of Contents