Position Control Switch Assembly
Removal
1. Remove the left side panel as described on page 6–4 of Chapter 6,
Replacement Procedures.
2. Disconnect P4–1 (1) of the position control switch cable assembly from
the lower portion of J4 on the stacker PCBA.
3. Remove two screws (3) to remove the position control switch assembly
(4) from the support bracket (5).
Installation
1. Install the position control switch assembly and secure it with two
screws.
2. Feed the P4–1 cable through the cable slot on the stacker column and
plug P4–1 into the lower portion of J4 on the PCBA.
3. Install the left side panel as described on page 6–4 of Chapter 6,
Replacement Procedures.
A–10
(Figure A–5)
Power Paper Stacker Maintenance