Table of Contents
Advertisement
SHUTTLE STALL
Instruction
1.
Check that forms thickness
adjustment lever is not
closed too tightly; this can
jam the ribbon and shuttle.
2.
Run a diagnostic self–test
(page 4–14) and check for
shuttle obstruction.
3.
Check the magnetic pickup
sensor for proper gap and
output (page 5–20), and a
broken or loose connector.
4.
Run a shuttle/ribbon test.
5.
Check for a broken or
damaged shuttle belt.
6.
Run a shuttle/ribbon test.
7.
Run a shuttle/ribbon test.
8.
Run a shuttle/ribbon test.
STACKER
Instruction
1.
Check for proper paper
stacking when using the
power paper stacker.
4–10
Indication
Forms thickness
adjustment lever is set
correctly.
SHUTTLE STALL
message.
SHUTTLE STALL
message.
SHUTTLE STALL
message.
Belt is damaged.
SHUTTLE STALL
message.
SHUTTLE STALL
message.
SHUTTLE STALL
message.
Indication
STACKER message.
Yes
Step 2.
Readjust the
setting of the
forms thickness
adjustment lever.
Go to step 2.
Remove the
Return printer to
obstruction and go
normal operation.
to step 3.
Replace the MPU
Return printer to
(page 6–42). Go
normal operation.
to step 4.
Step 5.
Return printer to
normal operation.
Replace the
Step 6.
shuttle belt (page
6–48). Go to step
6.
Replace one at a
Return printer to
time until the
normal operation.
message
disappears:
mechanism driver,
MCU, or DCU
PCBA (page
6–72). Go to step
7.
Replace the
Return printer to
shuttle motor
normal operation.
(page 6–44) and
go to step 8.
Replace the
Return printer to
shuttle assembly
normal operation.
(page 6–18).
Yes
Clear the paper
Return printer to
exit path.
normal operation.
Troubleshooting
No
No
Advertisement
Table of Contents
Troubleshooting
