Printronix P9012 Maintenance Manual page 164

Installation
1. Position the motor in the printer.
2. Support the motor and install four carriage bolts (17), washers (16),
lockwashers (15), and nuts (9). Do not tighten.
3. Connect shuttle motor connectors P34 and P40.
4. Slip the belt over the motor pulley.
5. Check and adjust the shuttle belt tension as described on page 5–24 of
Chapter 5, Alignments and Adjustments.
6. Position the cam cover with attached gasket on the base support.
7. Install two screws (5).
8. Install the lower paper guide, two clips, and four washers (3) and screws
(2). Close the upper paper guide.
9. Close the rear door and the top cover. Connect the AC power cord.
6–46 Replacement Procedures