Table of Contents
Advertisement
Installation
1. While holding the spring and spring seat in place, install the
counterweight.
2. Install three screws (6), lockwashers (7), and washers (8).
3. Install one screw (11), lockwasher (9), and washer (12). Leave the screw
loose about three turns.
4. Using a hex–tipped screwdriver, push on screw (11) and install the
shim(s).
5. Tighten screw (11).
6. Install the cam front cover plate, gasket, and six screws (3).
7. Set the counterweight preload as described on page 5–6 of Chapter 5,
Alignments and Adjustments.
8. Install the cam cover and tighten two captive screws (1).
9. Install the right side panel as described on page 6–4.
10. Close the top cover and connect the AC power cord.
6–34
Replacement Procedures
Advertisement
Table of Contents
Troubleshooting
