Dc Power Bus Assembly - Printronix P9012 Maintenance Manual

DC Power Bus Assembly

Removal
1. Remove the card cage as described on page 6–76.
2. Remove three nuts (1) and washers (2).
3. Remove two screws (3) in six places.
4. Separate the DC power bus assembly (4) from the card cage (5).
Installation
1. Place the DC power bus assembly on the card cage.
2. Install two screws in six places.
3. Install three washers and nuts.
4. Install the card cage as described on page 6–84.
6–90
(Figure 6–29)
Replacement Procedures