Flywheel Assembly
Removal
1. Remove the counterweight assembly as described on page 6–32.
Do not adjust the MPU clamp screw as it affects the MPU gap.
2. Back out the screw (1) about .25 inch.
3. Move the MPU arm (2) away from the flywheel (3) as far as the support
plate (4) allows.
4. Remove two screws (5) and lockwashers (6) from the flywheel axle.
5. Slip the flywheel assembly out of the shuttle belt (7) and lift it out of the
base support (8).
6–36
(Figure 6–11)
CAUTION
Replacement Procedures