Card Cage - Printronix P9012 Maintenance Manual

Card Cage

(Figure 6–26)
Removal
1. Disconnect the AC power cord from the rear of the printer.
2. Remove the right side panel as described on page 6–4.
3. Loosen the four screws (1) which secure the two card cage covers (2, 3).
Do not remove the screws. Remove the card cage covers by sliding them
up and out.
4. Disconnect the cables (4) from the PCBAs in the card cage (5).
Disengage the cables from the clips (6) mounted along the bottom edge
of the card cage.
6–76
(continued on page 6–78)
Replacement Procedures