Paper Feed Belt
Removal
1. Disconnect the AC power cord from the rear of the printer. Open the top
cover.
2. Remove the right and left side panels as described on page 6–4.
3. Remove two screws (1) and the belt guard (2).
4. Loosen the setscrew (3) in the bushing (4).
5. Slide the bushing off the splined shaft (5).
6. Shift the splined shaft to the right until the bearing (6) is free of the right
side plate (7).
NOTE: If the belt tension prevents step 5 from being performed, loosen four
7. Slip the belt (10) off the paper feed motor pulley (11).
8. Remove the belt by slipping it off the forms adjustment pulley (12).
6–52
(Figure 6–17)
screws (8) and allow the motor (9) to shift, thus reducing belt
tension.
Replacement Procedures