Printronix P9012 Maintenance Manual page 202

Installation
To install the card cage, refer to Figure 6–26 (1 through 4) on the preceding
pages and perform the following steps:
1. Slide the card cage assembly part way into the printer.
2. Mount the six hammer driver connectors (21) to the rear of the card cage
with twelve screws (20).
3. Slide the card cage assembly all the way into the printer.
4. Attach blower fan connector P18 (17) to J18.
5. Attach all required connectors (15) to the logic backplane.
6. Route connector P17A (18) up through the opening in the printer frame
and connect it to the exhaust fan connector.
7. Attach the card cage ground wire (19) to the printer cabinet with a
starwasher and nut. Engage the wire in the clips.
8. Secure the card cage with six screws (14), four in the front and two in the
back.
9. Install the I/O panel as follows:
a. Attach the I/O panel ground wire (13) to the printer cabinet with a
b. Connect transformer connector P2 (11) to J2 (12).
c. Connect all seven terminals to the circuit breaker.
a. Secure the I/O panel with five screws (8).
10. Route the interface cables from the I/O panel to the card cage. Connect
the cables to the appropriate PCBAs in the card cage. Engage the cables
in the clips along the bottom front edge of the card cage.
11. Install the card cage covers and tighten the four screws (1).
12. Install the right side panel as described on page 6–4.
13. Connect the AC power cord to the rear of the printer.
6–84
starwasher and nut. Engage the wire in the clips.
Replacement Procedures