Motor Assembly - Printronix P9012 Maintenance Manual

Motor Assembly

Removal
1. Remove the left side panel as described on page 6–4 of Chapter 6,
Replacement Procedures.
2. Disconnect P2 (1) of the motor cable assembly from J2 on the PCBA.
3. Loosen the set screw (2) nearest the motor on the coupling (3).
4. Remove four screws (4).
5. Remove the motor assembly (5).
Installation
1. Install the motor assembly and secure with four screws. Make sure the
motor shaft is in the coupling. Tighten the coupling set screw.
2. Route the motor cable through the cable slot in the stacker column.
Connect P2 to J2.
3. Install the left side panel as described on page 6–4 of Chapter 6,
Replacement Procedures.
A–6
(Figure A–3)
Power Paper Stacker Maintenance