Side Panels - Printronix P9012 Maintenance Manual

Side Panels

(Figure 6–1)
NOTE: The replacement procedure for the right and left side panel is
Removal
1. Raise the top cover.
2. Loosen two captive screws (1).
3. Lift the right side panel (2) off of the support pins (3) and remove the
panel from the printer.
Installation
When installing the right side panel, take care not to damage or distort
the rubber seal on the front panel.
1. Place the right side panel on the support pins.
2. Tighten the two captive screws.
3. Close the top cover.
6–4
identical. Only the right side panel is discussed below.
CAUTION
Replacement Procedures