Ribbon Deck
(Figure 6–3)
Removal
1. Open the front door of the printer and disconnect two connectors (1)
from the bottom of the ribbon deck assembly (2).
2. Squeeze the lock tabs (3) and remove the ribbon spools (4) from the
ribbon hubs (5).
3. Remove two hex head screws (6).
4. Raise the ribbon deck assembly slightly and lift it off the retaining clips
(7).
5. Remove the ribbon deck assembly from the printer.
Installation
1. Place the ribbon deck assembly in the printer on the retaining clips.
2. Connect two connectors.
3. Install two hex head screws (6).
4. Install the ribbon spools on the ribbon hubs.
6–8
Replacement Procedures