Hammer Driver Backplane Pcba - Printronix P9012 Maintenance Manual

Hammer Driver Backplane PCBA

Removal
1. Remove the card cage as described on page 6–76.
2. Disconnect the connector (1).
3. Remove two screws (2) in three places.
4. Separate the hammer driver backplane PCBA (3) from the card cage (4).
Installation
1. Place the hammer driver backplane PCBA on the card cage.
2. Install two screws in three places.
3. Connect the connector.
4. Install the card cage as described on page 6–84.
6–92
(Figure 6–30)
Replacement Procedures