Card Cage Fan - Printronix P9012 Maintenance Manual

Card Cage Fan

NOTE: There are two card cage fans. The following procedure applies to
Removal
1. Remove the card cage as described on page 6–76.
2. Remove four screws (1) and washers (2).
3. Disconnect the connector (3).
4. Separate the fan (4) from the card cage (5).
Installation
1. Place the fan in the bottom of the card cage.
2. Connect the connector.
3. Install four screws and washers.
4. Install the card cage as described on page 6–84.
6–86
(Figure 6–27)
either.
Replacement Procedures