Table of Contents
Advertisement
Installation
1. Connect the cable to the sensor.
2. Place the sensor on the left tractor.
3. Install the nut, washer (8), and retainer.
4. Inspect installation to verify that both apertures in the sensor are visible.
If not, loosen the screws and reposition as necessary.
5. Move the support shaft to the left and into the left tractor.
6. Screw the support shaft into the knob.
7. Install one screw and washer (4).
8. Adjust the paper motion sensor as described on page 5–28 of Chapter 5,
Alignments and Adjustments.
9. Install the right side panel as described on page 6–4.
10. Load paper, connect the AC power cord, and close the top cover.
6–64
Replacement Procedures
Advertisement
Table of Contents
Troubleshooting
