Chery Tiggo 2009 Service Manual page 693

3.
CHECK THE TPS POWER SUPPLY CIRCUIT - (1)
• Turn ignition switch on.
• Check TPS supply voltage between sensor terminal
3 and ground in the sensor electrical connector
E-027.
• Approximately 5 V should exist.
Is the check result normal?
Yes >>
Go to step 8.
No >>
Go to the next step.
4.
CHECK THE TPS POWER SUPPLY CIRCUIT - (2)
• Disconnect ECM harness connector (1).
• Turn ignition switch off.
• Check harness continuity between TPS terminal 3 and ECM terminal 32.
• Continuity should exist.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Repair or replace circuit for an open.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
03
LTSMD030035
LTSMD030077
409
03–