Chery Tiggo 2009 Service Manual page 652

Check reference values between ECM terminals and ground under the following conditions:
ECM TERMINAL NO.
6
7
27
47
On Board Diagnostic Logic
• Self-diagnosis detection logic.
DTC NO.
P0262
P0265
P0268
P0271
DTC Confirmation Procedure:
Before performing the following procedure, confirm that battery voltage is more than 12 V.
• Turn ignition switch off.
• Connect the X-431 scan tool to the Data Link Connector (DLC) - use the most current software available.
• Turn ignition switch on.
• With the scan tool, record and erase stored DTCs in the ECM.
• Start engine and warm it to normal operating temperature then select view DTC.
• If DTC is detected, go to Diagnostic Procedure - Step 1.
• If the DTC is not detected, the DTC condition is intermittent (See Diagnosis & Testing Diagnostic Help in Sec-
tion 03 Electronic Engine Controls).
NOTE :
While performing electrical diagnosis & testing, always refer to the electrical schematics for specific circuit
and component information.
Diagnostic Procedure
1.
CHECK GROUND CONNECTIONS
• Turn ignition switch off.
• Loosen and retighten ground screws on the body (See Ground Inspection in Section 03 Electronic Engine Con-
trols).
• Inspect ground connections E-207 and E-208 mounting position (See Vehicle Wiring Harness Layout - Engine
Room Harness (With 2.0L Engine) in Section 16 Wiring).
Are the ground connections OK?
Yes >>
Go to the next step.
No
>>
Repair or replace ground harness or connections.
368
03–
DIAGNOSIS & TESTING
ITEM
Injector 2
Injector 3
Injector 1
Injector 4
DTC DEFINITION
Cylinder 1 - Injector Circuit
High
Cylinder 2 - Injector Circuit
High
Cylinder 3 - Injector Circuit
High
Cylinder 4 - Injector Circuit
High
CONDITION
• Engine is running
• Warm-up condition
• Idle
• Accelerate suddenly
DTC DETECTION
CONDITION
Engine is running
Chery Automobile Co., Ltd.
DATA (AVERAGE DC
VOLTAGE)
Voltage: 11 V - 14 V
POSSIBLE CAUSE
• Injector
• Harness or connectors
• ECM