Chery Tiggo 2009 Service Manual page 638

Diagnostic Procedure
1.
CHECK GROUND CONNECTIONS
• Turn ignition switch off.
• Loosen and retighten ground screws on the body (See Ground Inspection in Section 03 Electronic Engine Con-
trols).
• Inspect ground connections E-207 and E-208 mounting position (See Vehicle Wiring Harness Layout - Engine
Room Harness (With 2.0L Engine) in Section 16 Wiring).
Are the ground connections OK?
Yes >>
Go to the next step.
No >>
Repair or replace ground harness or connections.
2.
CHECK TPS ELECTRICAL CONNECTOR
• Disconnect the TPS electrical connector (1).
• Inspect the electrical connector for damage.
Is the electrical connector OK?
Yes >>
Go to the next step.
No >>
Repair or replace the electrical connector
as necessary.
354
03–
DIAGNOSIS & TESTING
Chery Automobile Co., Ltd.
VISMD030203