Table of Contents
Advertisement
Memory Diagnostic
1.
Do one of the following:
a.
For direct access, attach the SUV cable (supplied with the HP X5000 G2 Network Storage
System) to the port on the front of the server blade you want to recover. Connect a monitor
and USB mouse to the SUV cable. Using the remaining USB connector on the SUV cable,
connect either a USB DVD drive (and insert the System Recovery DVD) or a bootable USB
flash device (prepared with a System Recovery image).
b.
For remote management access, connect to the server using iLO from a client PC. Insert
the System Recovery DVD in the client PC or attach a bootable USB flash device that has
been prepared with a System Recovery image.
2.
Reboot the server blade to either the USB flash device or USB DVD drive.
The system BIOS attempts to boot to the USB device first by default. Watch the monitor output
during the boot as you may need to press a key to boot to the USB media
NOTE:
boot sequence. If connected remotely, you may have to change some iLO settings to ensure
proper boot sequence.
3.
Select Windows Recovery Environment.
The recovery environment is loaded.
4.
Once the recovery environment is loaded, the System Recovery Options wizard opens. On
the first window, select the keyboard input method, which is based on your location (for
example, select US for United States) and click Next.
5.
Select either of the following options (it does not matter which option is selected) and click
Next:
Use recovery tools that can help fix problems starting Windows. Select an operating
system to repair.
Restore your computer using a system image that you created earlier.
6.
Click Cancel until the Choose a recovery tool window opens.
7.
Click Windows Memory Diagnostic.
8.
Select one of the following options:
Restart now and check for problems. Select this option to restart the system and scan for
memory issues. Do not remove the attached USB DVD or USB flash drive.
Check for problems the next time I start my computer. Select this option to schedule a
memory diagnostic after you restart the system. Do not remove the attached USB DVD or
USB flash drive.
HP 1210m Volume Online Tool
Use the HP 1210m Volume Tool to manually set all volumes online. Manually setting volumes online
may be necessary if a disk enclosure is powered down before the server blades are powered
down and the enclosure contains disks with LUNs on them.
IMPORTANT:
data loss.
The tool is included (but not installed) with HP X5000 G2 software version 2.02.0a or later.
To install the tool:
1.
Navigte to the C:\hpnas\support directory on the server blade.
2.
Double click Volume_Manager_Install.msi.
To use the tool:
If directly connected, you may have to change the BIOS settings to ensure proper
You should only use this tool under the guidance of HP Support to avoid potential
HP 1210m Volume Online Tool
53
Advertisement
Table of Contents
