Table of Contents
Advertisement
5.
Push down on the SAS I/O module lever (2,
SAS I/O module (3,
NOTE:
Figure 57 Removing the SAS I/O module
Replacing the SAS I/O module
1.
To install the replacement SAS I/O module
a.
Insert the SAS I/O module into the enclosure (1).
b.
Push up on the SAS I/O module lever (2) until it locks into place.
NOTE:
Figure 58 Replacing the SAS I/O module
2.
Plug in all cables to the SAS I/O module.
IMPORTANT:
removed or the system might fail.
3.
Verify that the replacement SAS I/O module is working properly by checking the overall
module status LED
NOTE:
module is inserted in the system, which reflects the necessary time to boot the firmware.
74
Removing and replacing hardware components
Figure 57 (page
You may need to use significant force to accomplish this task.
You may need to use significant force to accomplish this task.
You must install the SAS I/O cables in the same slots from which they were
("SAS I/O module LEDs status" (page
The green overall module status LED should turn on within five seconds after the new
Figure 57 (page
74)).
(Figure 58 (page
41)).
74)), and then remove the failed
74)):
Advertisement
Table of Contents
