Table of Contents
Advertisement
4.
Remove the server blade
a.
Push the button to release the handle (1).
b.
Pull the handle toward you (2).
c.
Remove the server blade (3).
Figure 130 Removing the server blade
5.
Press the release button on the access panel and slide the access panel to the left to remove
it.
6.
The original 1210m cache module is connected to a capacitor pack, so observe the cache
module LEDs:
If the amber 1210m cache LED is solid, data transfer to the flash device on the cache is
in progress. Do not remove the 1210m cache until the amber LED is off, and then continue
with the next step.
If the amber 1210m cache LED is not lit, proceed to the next step.
7.
Open the ejector latches (1,
slot.
Typically, opening the ejector latches ejects the cache module automatically. If the module
does not eject automatically after you open the ejector latches, remove the cache module (2)
by grasping only the edges.
Figure 131 Removing the cache module
8.
Remove the capacitor pack (2,
The 1210m cache module (1), and the 1210m controller card (3) are also shown.
1 14
Removing and replacing hardware components
(Figure 130 (page
114)):
Figure 131 (page
114)) on each side of the 1210m cache module
Figure 132 (page
115)).
Advertisement
Table of Contents
