HP X5000 G2 Administrator's Manual page 148

SHOW SERVER NAMES
Syntax
SHOW SERVER NAMES
Description
Displays a brief description of all server blades.
Restrictions
This command functions only if the enclosure power is already on. If power is not on, the command
responds with the message: "enclosure power is off". If power is coming on but state exchange
between iLO and EM have not normalized, some displayed information might display [Unknown]
or ?.
SHOW SERVER BOOT
Syntax
SHOW SERVER BOOT { ALL | <bay#> [{ - | , } <bay#>]}
Description
Displays the boot order and one-time boot device for the specified server or range of servers. These
settings correspond to the server boot settings in the ROM-Based Setup Utility.
Restrictions
This command functions only if the enclosure power is already on. Because the EMU hardware
cannot determine if a blade is physically present unless enclosure power is on, the EM reports the
warning that the blade is not present if this command is used when enclosure power is off.
SHOW SERVER INFO
Syntax
SHOW SERVER INFO { ALL | <bay#>[{ , | - } <bay#>]}
Description
Displays a description of the server blade hardware, including the embedded NICs, the Mezz
HBAs, and the management processor, in the specified bays.
Restrictions
This command functions only if the enclosure power is already on.
SHOW SERVER LIST
Syntax
SHOW SERVER LIST
Description
Displays a brief iLO and status description of all server blades. For a longer description, use SHOW
SERVER INFO.
148 Managing the EMU