Table of Contents
Advertisement
1.
If your storage system is delivered in a rack, proceed to Step 2. If you ordered the storage
system without the rack, install the rail kit and enclosure in the rack using the installation
instructions that are included with the rail kit.
IMPORTANT:
system operation or maintenance. Bind cables loosely with cable ties and route the excess
out of the way, along the side of the rack, to keep system components and indicators visible
and accessible.
Figure 3 Storage system installed in a rack
1. Storage system enclosure
2-5. Disk enclosures (optional)
6-7. Cable connection, with no bend radius smaller than 5 cm
2.
If you purchased disk enclosures, rack and cable the disk enclosures before moving to the
next step.
3.
Cable the storage system to your network and attach the power cords. See
(page 8)
Cable disk enclosures
The following figures show the correct cabling of disk enclosures to the storage system chassis.
Numbers represent the order of attachment.
Storage System with two disk enclosures.
10
Installing the storage system
Ensure that cabling in the back of the rack system does not interfere with
for connecting the power cables.
Figure 4 (page 11)
shows an HP X5000 G2 Network
"Rear view"
Advertisement
Table of Contents
