Table of Contents
Advertisement
Configure the EMU and iLO management processors
Before configuring the management processors, verify the following:
You have determined whether the network ports on the server are to use DHCP or static
addresses. If the network ports are to use static addresses, you must provide the addresses.
For this step, the EMU port should not be connected to a switch. You can connect the EMU
port to a switch after the EMU and iLO NICs are configured.
Configure the EMU and iLO management processors for both servers as follows:
1.
Connect a system (the configuration system) in the environment or a laptop to the EMU port
(Figure 8 (page
Figure 8 EMU NIC port connection
2.
Configure the networking properties for the local system:
a.
Open Control Panel, select Network Sharing Center or Network Connections, and navigate
to Local Area Connections.
b.
Select Properties Internet Protocol, and then select Properties.
c.
If Use the following IP address: is selected, record values for the following items and
restore them after completing the EMU and iLO setup:
d.
Enter the following values:
e.
Before continuing, ping the following IP addresses to test connectivity to the EMU and
the iLO located in each of the servers: 10.0.0.10, 10.0.0.1 1, and 10.0.0.12. The EMU
and iLO interfaces have been assigned IP addresses during factory setup. You must either
update the factory values with site-specific static IP addresses or configure the management
processors to use DHCP IP addressing.
15)). You can use either a crossover or a regular Ethernet cable.
IP address
Subnet mask
Default gateway
IP address: 10.0.0.20
Subnet mask: 255.255.255.0
Configure the EMU and iLO management processors
15
Advertisement
Table of Contents
