Show Network - HP X5000 G2 Administrator's Manual

PING
Syntax
PING IPV6 [<NUMBER>] {<ipv6 address> | "<server name>"}
Description
Sends ICMP echo messages to a remote IPv6 device. If you omit <NUMBER>, or use a number
larger than 9999 or one that is negative, then only four packets are sent. Packets are sent at
one-second intervals to prevent congestion.
Restrictions
<NUMBER> must be between 1 and 9999.
IPv6 must be enabled.
<ipv6 address> must be in the format ####:####:####::##.
SET IPCONFIG
Syntax
SET IPCONFIG { DHCP | STATIC | LOCAL }
Description
Configures EM addressing mode to be DHCP, static, or link local. The setting takes effect
immediately. If mode chosen is static, other parameters are required (see below).
Restrictions
None
SET IPCONFIG STATIC
Syntax
SET IPCONFIG STATIC <ip address> <netmask> [<gateway>]
Description
Configures the IP settings for the EM to static mode. In selecting this mode, the IP address and
netmask are be set to <ip address> and <netmask>, respectively. These settings take effect
immediately. The gateway address will be cleared if it is omitted. Note that you can also set the
gateway address using the SET EM GATEWAY command.
Restrictions
None

SHOW NETWORK

Syntax
SHOW NETWORK
Description
Displays the network settings of the Enclosure Manager.
Internet control 145