Table of Contents
Advertisement
Description
Shows information for the IO modules within the enclosure: SAS, LOM, MEZZ, and PCIe.
Restrictions
Should be used only when enclosure power is on.
If enclosure power has never been turned on, no information is available. If it was on but is
now off, only the firmware version of the IO modules that have firmware is shown.
SHOW RACK
Syntax
SHOW RACK { NAME | ID }
Description
Displays user-defined rack name (string) or id (0...255) that is part of the persistent EMU
configuration.
Restrictions
If rack name has not been set, it is UnnamedRack.
If rack id has not been set, it is 0.
SHOW SERVER TEMP
Syntax
SHOW SERVER TEMP { ALL | <bay#>[ { , | - } <bay#>] }
Description
Displays temperature sensor information for the specified server or range of servers. This data is
provided by iLO to the EM, which has no direct sensor access.
Restrictions
The enclosure must be powered on, otherwise, iLO has no power and cannot sense temperature
or send data to the EM.
Internet control
The following commands define the EM 1.0 or later CLI functions for Internet control.
ADD EBIPA
Syntax
ADD EBIPA { SERVER } DNS <ip address>
Description
Adds an EBIPA DNS server IP address to the list of DNS servers for server bays.
Restrictions
A maximum of three DNS servers can be added for EBIPA.
<ip address> must be in the form ###.###.###.###, where each ### ranges from 0 to
255.
Internet control 143
Advertisement
Table of Contents
