Table of Contents
Advertisement
3 Configuring the storage system
This chapter explains the out of box experience that occurs when you first power on the storage
system. This includes setup tasks, such as the selection of language and regional settings for the
OS, network configuration, time zone, provisioning storage required for the cluster, and deploying
the two-node cluster. All configuration may be done from a single server. There is no need to log
on to the second server.
Accessing the storage system
For initial configuration of the storage system, you must have console access to one of the server
blades. You can use either a local I/O diagnostic (SUV) cable or an iLO connection. The iLO
connection is the preferred method because it allows for remote access. If you are using the direct
connect method, connect the supplied SUV cable to the front of the storage system server blades
in the following sequence: keyboard, mouse, monitor cable, and monitor power cable. Regardless
of which access method you use, perform the configuration from only one of the server blades.
The server blade you choose for configuration will be designated the first node, and the other
server blade will be designated the second node.
Figure 1 1 Keyboard, mouse, and monitor
1. Storage system enclosure
2. Monitor
3. Keyboard (USB)
4. Mouse (USB)
NOTE:
The keyboard, mouse, and monitor are not provided with the storage system.
For remote access, open a web browser and enter the iLO name or IP address for a server blade
located in either bay. Log in using the iLO administrator name and newly created password for
that blade.
For instructions on using iLO, see the Integrated Lights Out user guide available from
www.hp.com/go/ilo. On the iLO web page, select More iLO Documentation.
Set up Windows and discover the second node
When the storage system starts, the servers will begin a first time setup procedure that takes
approximately 10 to 15 minutes, including the Set Up Windows wizard. Use only one node to
complete the setup procedure.
http://
Accessing the storage system
19
Advertisement
Table of Contents
