Table of Contents
Advertisement
Figure 109 Reattaching the plug bracket to the coil power plug
5.
Push the drive drawer fully back into the system enclosure (1,
handle back into place (2).
Figure 1 10 Pushing the drive drawer into the system enclosure
6.
Replace the top back panel.
7.
Replace the enclosure as described in
Removing and replacing the enclosure rails
Removing the enclosure rails
1.
Power off the system as described in
2.
Remove the enclosure as described in
"Inserting the system enclosure into the rack" (page
"Powering the storage system off and on" (page
"Removing the system enclosure from the rack" (page
Removing and replacing the enclosure rails 103
Figure 1 10 (page
103)) and the
68).
60).
67).
Advertisement
Table of Contents
